Henderson Plastics Ltd
Lyng Hall Road
Wood Norton
Dereham
Norfolk
NR20 5BJ
Tel: 01362 683 364
E-mail

Hendersons Logo
contractors worktop jig

Worktop JIGS
for ¼" AND ½" Routers

Order Total:

© Henderson Plastics Ltd

Order Total:

Worktop joint jig clamp and bolts
Router Banner

For an easy DIY Project

Supplied with full illustrated instructions and locator pegs.
A range of templates for use with most makes and model of professional and DIY router with either ½" or ¼" collet.
All templates are made from tough, wear resistant industrial grade plastic to give years of accurate service. The template is used to guide the router when machining left and right hand mason mitre (Butt & Scribe) joints - both male and female parts- out of square joints and connector bolt slots in post formed worktops and window boards.
With the instructions guiding the user through each step of the process, smart accurate joints can be produced in minutes.

FOR AN EASY DIY PROJECT
when  machining left and right hand mason mitre (Butt & Scribe) joints - both male and female parts- out of square joints and connector bolt slots in post formed worktops and window boards.
With the instructions guiding the user through each step of the process, smart accurate joints can be produced in minutes.
Supplied with full illustrated instructions and locator pegs.
A range of templates for use with most makes and model of professional and DIY router with either ½" or ¼" collet.
All templates are made from tough, wear resistant industrial grade plastic to give years of accurate service. The  template  is  used to guide  the router

Each template is predrilled to accept the locator pegs, and all holes are permanently marked with reference numbers to ensure accurate and speedy set up prior to the machining operation. Window boards and postformed worktops of 300, 450, 500, 600, 618 and 650mm can be cut using the standard predrilled hole settings in the template.

A finished kitchen worktop corner joint
A finished corner mitre in a 600mm wide postformed kitchen worktop.
This joint was produced with a ¼" pocket cutter in a 500W DIY router

Each template is pre drilled to accept the locator pegs, and all holes are permanently marked with reference numbers to ensure accurate and speedy set up prior to the machining operation. Window boards and postformed worktops of 300, 450, 500, 600, 618 and 650 mm can be cut using the standard pre drilled hole settings in the template.

Joint detail with the two boards pulled slightly apart
kitchen worktop corner joint

A finished corner mitre in a 600 mm wide postformed kitchen worktop.
This joint was produced with a ¼" pocket cutter in a 500W DIY router.

Joint detail with the two boards pulled slightly apart.